You have reached your limit of 3 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Power Steering Added To Deere 1020
Ken Haag, Unionville, Mich.: “I added power steering to my Deere 1020. To do it, I had to remove a steel ball bearing pressed into the transmission case. It was deep. I used a small chisel to get enough clearance to weld a nut onto it and used a slide hammer to remove it. Worked great.
“I have a bucket truc
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Power Steering Added To Deere 1020 TRACTORS Miscellaneous Ken Haag Unionville Mich : “I added power steering to my Deere 1020 To do it I had to remove a steel ball bearing pressed into the transmission case It was deep I used a small chisel to get enough clearance to weld a nut onto it and used a slide hammer to remove it Worked great “I have a bucket truck fitted with an Onan generator that would not stay running It would start for a few seconds and then shut off The circuit board that controls it has a relay that is energized by the voltage output of the generator but the ‘seal in’ contacts had failed They were opening after a few seconds I solved the problem by just ‘jumpering’ around them with wire saving a few hundred bucks ”
To read the rest of this story, download this issue below or click
here to register with your account number.
